Broke and alone but a AA battery, a sheet of copper wire, as well as a neodymium magnet, you can make your personal miniature motor. This will make to get a neat trick, but it really generally is a bit difficult to begin. The bottom line is to manufacture a shape outside of wire that stays in constant experience of the magnet and the positive terminal with the battery, but won't squeeze it too tightly

1

Receive a small neodymium magnet. It must be no less than 1/4 inch thick, and slightly thinner when compared to a AA battery (1/2 inch diameter is effective.) These magnets are difficult to get at hardware stores, however you can order them from many web shops, for example K&J Magnetics.

2

Cut a amount of wire. I would recommend starting with about 10 inches, although this can be project to comprehend or less.

3

If your wire has any insulation, make the grade off. Either peel it away while using wire strippers or complete a small cut just deep enough to undergo the insulation with the wire cutters, then pull it off together with your fingers.

4

Produce a small loop down the middle of the wire. The loop really should be just large enough to adjust to across the circumference with the battery.

5

Placed the magnet on the bottom in the battery. Try to center it as accurately as you can.

6

Twist the two ends from the wire together. Don't get worried in regards to the form of the wire yet.

7

Bend the wire so your point where the wires join faces down and the distance between your top and bottom on the wire may be the right size for your battery to adjust to in. When the top wires touch the superior of the battery, the loop at the bottom must be throughout the magnet.

8

Place the wire within the battery with all the magnet flanked by the loop. It should start spinning immediately.

9

Should the wire doesn't start spinning, adjust it. It ought to be in touch with the most notable with the battery plus the magnet, but should not be too tightly connected. If this squeezes the magnet, as an example, the friction could stop it from spinning.

Tags: neodymium magnets neodymium magnet Smco magnets